Bulldozer — Shed Pad

Machine Before - Dugong - Machine After

The machine before Dugong determines what material arrives; the machine after Dugong determines what surface must leave. An excavator can expose formation, a loader can deliver a stockpile, and a roller can compact the placed layer. The scraper's role is bounded by those interfaces.

Before moving material

Identify the upstream operation and its remaining defects.

Receiving operation and checks

Hand over the measured surface to compaction, cultivation, paving or turf preparation. Record which operation owns levels, materials and final acceptance.

The workflow can include Dugong where suitable; it does not assume Dugong replaces adjacent equipment.

Shed Pad Preparation

A shed pad must support its intended use and remain connected to access and drainage. Light storage, vehicle use and other activities can require different formation and material decisions.

Before moving material

Confirm shed layout, floor level, access loads and services.

Receiving operation and checks

Complete compaction and the shed builder's required checks. Inspect transitions at doorways and runoff routes beside the pad.

The machine selection does not establish structural suitability.

Bulldozer to Grading Workflow

A bulldozer can move substantial material by pushing; a scraper can collect and carry selected material between defined points. The handover should occur when broad quantity movement gives way to controlled placement or trimming.

Before moving material

Complete bulk pushing and establish the remaining surface error.

Receiving operation and checks

Fine grade and independently check the surface. Inspect broad joins between dozer runs and receiving areas.

Where the dozer can finish efficiently, adding another machine may not improve the job.

Record the job inputs

Use this checklist to turn the scenario into a specific brief. Retain the design revision and agree who accepts each completed layer.

• Existing condition, extent and the reason for intervention
• Required finished purpose, receiving operation and acceptance criteria
• Material type, layer role, source, receiving area and volume state
• Reference levels, datum, survey method and issued design revision
• Available tractor, implement configuration, travel route and turning space
• Checks before work, stopping points and evidence retained at handover

Checklist ticks apply only while this page is open. Include the completed brief in your project records.

Continue through the network

Surface and verification · Applications and rental · Equipment and technology